|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-19-2020, 12:51 PM | #1 |
Senior Member
Join Date: Nov 2011
Location: Readfield, Maine
Posts: 347
|
Ford Starter Rebuild
I am doing a rebuild of a ford starter and have removed the 2 brushes that are held on by screws. Now the other 2 are crimped on by heavy duty tabs. What is the best way to bend these tabs back to remove the brushes? They are are quite "stiff". I have tried several times to bend them back, trying not to disrupt where they go back into the starter winding's. Thank you.
|
10-19-2020, 02:04 PM | #2 |
Senior Member
Join Date: Jun 2018
Location: Minnesota
Posts: 347
|
Re: Ford Starter Rebuild
Those are soldered.
|
Sponsored Links (Register now to hide all advertisements) |
|
10-19-2020, 03:26 PM | #3 |
Senior Member
Join Date: May 2010
Location: Saratoga Springs, NY
Posts: 1,108
|
Re: Ford Starter Rebuild
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|