|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-15-2015, 08:24 PM | #1 |
Senior Member
Join Date: Jul 2010
Location: Keller, Tx
Posts: 114
|
29 Radiator measurements
I recently had my 29 radiator re-cored and I'm concerned they may have installed the new core about an inch higher than the old one. I took some measurements on the old core and I measured 18 1/2 " from the bottom of the top tank to the top of the bottom tank (core height). I don't think I measured wrong, but it's always possible and was wondering if anyone could measure their 29 radiator core height and post it. The measurement on the re-core is 19 1/2". Everything fit well before removing the old radiator. I haven't installed the new one yet, but I'm thinking the 1" extra height would make a significant difference in the way things fit.
Thanks, Bill
__________________
Bill Newland |
04-15-2015, 08:32 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,713
|
Re: 29 Radiator measurements
Have you tried putting the radiator shell on and seeing if the holes line up.
Bob |
Sponsored Links (Register now to hide all advertisements) |
|
04-15-2015, 11:53 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: 29 Radiator measurements
19 1/2" is correct. I just measured my original radiator.
|
04-16-2015, 06:26 AM | #4 |
Senior Member
Join Date: Jul 2010
Location: Keller, Tx
Posts: 114
|
Re: 29 Radiator measurements
Sponsored Links (Register now to hide all advertisements)
Bob, I'll be checking the fit of everything this weekend.
__________________
Bill Newland |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|