|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-12-2021, 03:38 PM
|
#1 |
|
Senior Member
Join Date: Dec 2013
Location: The Netherlands
Posts: 387
|
Orig. ign. Switch won’t fit repro panel
I have had this trouble before, but couldn’t find the answer. My 29 repro instrument panel has the cup for mounting the rebuilt original ignition switch. This cup is just not deep enough for the switch body to be installed. The screw holes were put in way too low under the edge of the cup. What do you guys do adjust things ?
__________________
You don’t own a Model A ... it owns you ! |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:00 AM.