|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-30-2022, 04:29 AM | #1 |
Member
Join Date: Mar 2014
Posts: 65
|
1950 Dana 44 Thrust washer
Dear community
My friend Yuri broke an axle shaft on his 1950 f1, Dutchman sent us the correct axle shaft, but while checking it all, the 2 thrust washers are broken Can someone sell me that part that I can't find ? Any help would be great Thanks Peter |
08-30-2022, 11:21 AM | #2 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,440
|
Re: 1950 Dana 44 Thrust washer
Those don't look like the side gear thrust washers used in the Dana 41 & 44. What rear axle does this pickup have in it?
The axles in the Dana 41/44 are 19-spline types and are held in place in the housing with the locked on bearings bolted in with side plates. The axles don't normally move around since they a splined into the side gears in the differential carrier case. Only the side gears have the 8M-4228 thrust washers and they are pretty large washers by comparison to the photos. They certainly don't look like those in the photos. |
Sponsored Links (Register now to hide all advertisements) |
|
08-30-2022, 06:42 PM | #3 |
Senior Member
Join Date: Nov 2010
Location: NM
Posts: 2,438
|
Re: 1950 Dana 44 Thrust washer
Here is the complete list of parts for 48-50 F-1's. It would be a Dana 41 unless someone has changed it out.
__________________
'52 F-1, EAB flathead |
08-31-2022, 02:03 AM | #4 |
Member
Join Date: Mar 2014
Posts: 65
|
Re: 1950 Dana 44 Thrust washer
This is a rear axle from a 1951 F1, axle shaft broke... when openning the rear axle in order to change the shaft, the washers were there, next to the locker unit...
|
08-31-2022, 11:50 AM | #5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,756
|
Re: 1950 Dana 44 Thrust washer
Here is a 1948-52 axle from Van Pelt's site. I only see two washers 8M-4230 3/4" ID 1 21/32" OD and 8M-4228 1 41/64" ID 2 13/16 OD.
|
08-31-2022, 03:03 PM | #6 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,440
|
Re: 1950 Dana 44 Thrust washer
Sponsored Links (Register now to hide all advertisements)
They do look like thrust blocks for a D44 Detroit Locker. They are available from several sources for around $25. A lot of lockers are for the later 30 spline axles. Last edited by rotorwrench; 08-31-2022 at 03:15 PM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|