I'll try again..

[Larry Jenkins]

My 1930 CCPU firewall came without the two brackets that hold the two radiator rods. The two areas on the firewall have been filled in with no indications as to where they used to be.

I want to reinstall the two brackets, but don't have the exact locations. Does any one have access to a template or the actual measurements?

I asked before, but I only got "12" apart." Need that horizontal spacing and the locations down from the rounded top.

Thank you!

Larry

[wrndln]

Larry,
The 28/29 CCPU carried over into about half of 1930. Is your 1930 CCPU the squarish style or the roundish style? I have a 29 CCPU I could measure, but I suspect you probably have a later 30 cab.
Rusty Nelson

[Larry Jenkins]

Originally Posted by wrndln

Larry,
The 28/29 CCPU carried over into about half of 1930. Is your 1930 CCPU the squarish style or the roundish style? I have a 29 CCPU I could measure, but I suspect you probably have a later 30 cab.
Rusty Nelson

It's the later cab. I wonder if the measurements for the two rod brackets would be the same..

Tom? Brent? Pluck?

Thanks guys..

Larry

[Charlie Stephens]

Can you see anything from the inside of the firewall?

Charlie Stephens

[700rpm]

Originally Posted by 1930 coupe

Is this what you need? I hope this is helpful.
All 4 rivet holes are in a straight line, they all measure different from the top because the top is a curved surface.

That is a very generous and thoughtful post!

[Larry Jenkins]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by 700rpm

That is a very generous and thoughtful post!

I thought so too! Great response. Thank you, 30 Coupe.

Charlie.. I looked but did not see any evidence of the old holes. 30s way should work well.

Thanks Gang!

Larry