|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-23-2020, 12:35 PM | #1 |
Member
Join Date: Oct 2012
Location: Bakersfield, Ca
Posts: 77
|
door panels 48 coupe
I am installing front door panels but I need bottom clip hole locations, could use the help THANKS
|
05-27-2020, 09:35 AM | #2 |
Senior Member
Join Date: May 2010
Location: New Jersey
Posts: 832
|
Re: door panels 48 coupe
You are probably going to need to make a template from the holes in the door.
|
Sponsored Links (Register now to hide all advertisements) |
|
05-27-2020, 10:23 AM | #3 |
Senior Member
Join Date: May 2010
Location: Napa,California
Posts: 6,029
|
Re: door panels 48 coupe
As suggested first make a pattern of the door and the existing holes. The standard clips to hold the panel are offset. Get a sample clip which will give you the offset and make the holes in the panel using the offset measurement from the clip..
|
05-27-2020, 01:02 PM | #4 |
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 1,825
|
Re: door panels 48 coupe
Clamp the panel in place and use a gizmo like this to locate the clip hole; then make the holes in the panel at the correct offset. I try to set them so the panel hangs from the clips.
|
05-28-2020, 07:38 AM | #5 |
Senior Member
Join Date: May 2010
Posts: 218
|
Re: door panels 48 coupe
If you have a friend that's an aircraft mechanic ask him to borrow a hole finder of the same diameter as the hole in the door.
|
05-29-2020, 05:04 AM | #6 |
Senior Member
Join Date: Feb 2016
Location: Plymouth, MA
Posts: 207
|
Re: door panels 48 coupe
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|