|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-01-2022, 09:27 AM | #1 |
Senior Member
Join Date: May 2010
Location: San Antonio, TX
Posts: 821
|
Toe in on front in
I know there is a way to check toe in using a 2x4 and some rubber bands but I cannot find it. Can anyone direct me to a place that has the procedure in writing/diagrams? Thanks in advance.
__________________
Brian SATX |
07-01-2022, 09:39 AM | #2 |
Senior Member
Join Date: Aug 2011
Location: Eagle Bend, MN
Posts: 2,025
|
Re: Toe in on front in
I just rolled the car on clean flat concrete for a couple wheel revolutions, then used a tape measure on the rim. Of course you have to first make sure your rims are true. I set mine for 1/8" toe in. This was about 10 years ago. Tire wear is even and it drives very well.
__________________
"There are some that can destroy an anvil with a teaspoon and shouldn't be allowed to touch anything resembling a tool." |
Sponsored Links (Register now to hide all advertisements) |
|
07-06-2022, 05:14 PM | #3 |
Junior Member
Join Date: May 2010
Posts: 3
|
Re: Toe in on front in
Sponsored Links (Register now to hide all advertisements)
If you are still in need, I have a toe measurement tool you can borrow. Tad Petrie |
|
|
Sponsored Links (Register now to hide all advertisements) |
|