|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-14-2017, 11:06 PM | #21 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Generator Rebuild
All I can think of is to get the screws even tighter, or try swapping sides with the shoes. I assume the inside of the case and the shoes were sandblast clean. The air gap is very small, so it only takes a spec of rust or dirt to make it tight.
|
01-19-2017, 09:18 PM | #22 |
Senior Member
Join Date: Aug 2014
Location: Southwick, MA
Posts: 590
|
Re: Generator Rebuild
The problem has been solved! I had installed that slip of paper that goes under the wire that connects the two field coils togethe a bit too high. I took it back to the shop where I had the pole screws tightened and after scratching our heads for a while, the shop owner noticed I had placed it just a little too high and some of it was under the pole shoe. He moved it down and now all is good! Thank you for your help!
|
Sponsored Links (Register now to hide all advertisements) |
|
01-19-2017, 11:46 PM | #23 |
BANNED
Join Date: May 2010
Location: Michigan / Ontario border, Sarnia, Ontario. 50 miles from Detroit and 150 from Toronto.
Posts: 5,800
|
Re: Generator Rebuild
Take it to the generator shop that didn't charge you originally. Wayne
|
01-20-2017, 12:16 AM | #24 |
Senior Member
Join Date: Dec 2011
Location: New hope Minnesota
Posts: 742
|
Re: Generator Rebuild
It always nice to hear the outcome of aproblem posted on the Barn. Many Thanks.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|