|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-10-2020, 07:52 AM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Cylinder Head Removal Tool
I would like to make the steel plate cylinder head removal tool that was described sometime back on Ford Barn. I have a scrap piece of 1/4 in. plate, would this be thick enough to do the job? Thank you, Ed
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:28 PM.