The Ford Barn

wright-47 · 04-05-2020, 07:57 PM

Just wondering if anyone has used a sealed bearing for the input shaft and not used the wick seal? I would think the oil drain hole would have to be sealed. Stay safe and healthy.

svm99 · 04-05-2020, 08:56 PM

Sponsored Links (Register now to hide all advertisements)

Use a ‘37 and later front bearing retainer with a seal. Seals are readily available. Use a shielded bearing.

04-05-2020, 07:57 PM	#1
wright-47 Member Join Date: May 2010 Location: Swift Current, Sask., Canada Posts: 33	36 Transmition bearings Just wondering if anyone has used a sealed bearing for the input shaft and not used the wick seal? I would think the oil drain hole would have to be sealed. Stay safe and healthy.

04-05-2020, 08:56 PM	#2
svm99 Senior Member Join Date: May 2010 Location: Garlic Country of CA Posts: 537	Re: 36 Transmition bearings Sponsored Links (Register now to hide all advertisements) Use a ‘37 and later front bearing retainer with a seal. Seals are readily available. Use a shielded bearing.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode