Sponsored Links (Register now to hide all advertisements)
Hello all,
I’ve been working on restoring an original OD-01 wiper and have it working, my question is if anyone has images for exactly how the wiper is mounted to the inside of the frame and what hardware is needed to do this to show quality correct. I’ve seen the repop clips but seems that these would make the shaft not align with the existing hole for the hand wiper. I’ve seen the service bulletin for routing the wire and such, it’s the mounting part that I’m stuck on. Any help with images would be greatly appreciated! My email is
[email protected] if that’s easier for sending images.
Best,
Mark
Portsmouth, NH