|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-26-2021, 03:33 PM | #1 |
Junior Member
Join Date: Jul 2021
Posts: 1
|
Model A Ford clutch pedal and pedal shaft collar
I am making adjustments to the excessive clutch play and am wondering if the brake and clutch pedal collar is supposed to fit snugly between the clutch pedal tabs. I have a fair amount of play when I pin the collar(new) on the shaft and am not sure if this play is normal or are the tabs on the clutch pedal worn?
|
07-26-2021, 04:05 PM | #2 | |
Senior Member
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,508
|
Re: Model A Ford clutch pedal and pedal shaft collar
Sponsored Links (Register now to hide all advertisements)
Quote:
The tabs on the factory blueprint are supposed to be ½" wide on both sides with ¼" depth of the tab. The overall width of the Pedal Shaft Bushing Housing (-not inclusive of the tabs) on the print shows that to be 2.030" wide. Depending on what year you are working on, there is a thin wavy washer that is between the brake pedal and the clutch pedal to keep pressure against the collar. This was typically found on May-June of 1929 until end of production. I hope that answers your question. |
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|