|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-05-2021, 07:22 PM | #1 |
Senior Member
Join Date: Jul 2019
Location: Southern Oregon
Posts: 782
|
Prony Brake Ideas
This is my concept of a simple Prony Brake Dyno.
It's probably a little over kill to use a 1 1/2 ton disk for a 150 HP engine but, it would be trouble free, I think to at least 250 HP. The way I drew it, is with a screw, to activate the MC. That way you could leave it will doing initial break in and it would make it easier to hold a torque reading. Again, with this type of brake, the HP, uses the formula, Torque x RPM Divided by 5252.
__________________
Frank '35 Ford Model 51 '48 Ford F3 '54 Ford Tudor Mainline Last edited by frnkeore; 01-06-2021 at 01:53 AM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|