|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-04-2019, 05:06 PM | #1 |
Senior Member
Join Date: May 2010
Location: Beaver Dam, Wisconsin
Posts: 821
|
Lincoln V-12 Distributor Parts
Bought a couple small boxes of Flathead parts at a swap meet last week and have been going through them to decide what to discard. There was a very gummed up rotor shaft and weights that I took part and cleaned yesterday that turned out to work very nicely. I was going to use this setup in a distributor that needed a rebuild when I figured out it wouldn't fit, too long. Compared to another and figured out it was for Lincoln not Ford. Went through more parts and a few more popped up including an old condenser marked Zephyr as well as two new ones. Not sure about vacuum lines especially the one on the left. Don't have a use for these parts and looking at boos-herril.com am unsure of value if I sell them. Any input is appreciated. And yes the rotors are not for Lincoln.
Last edited by GaryU.; 05-04-2019 at 05:08 PM. Reason: spelling |
05-04-2019, 09:29 PM | #2 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,260
|
Re: Lincoln V-12 Distributor Parts
Looks like Lincoln. Look on the tang end of the shaft and if it has an "H" stamped on it that would confirm Lincoln.
|
Sponsored Links (Register now to hide all advertisements) |
|
05-05-2019, 05:32 AM | #3 |
Senior Member
Join Date: May 2010
Location: Beaver Dam, Wisconsin
Posts: 821
|
Re: Lincoln V-12 Distributor Parts
Has 46 H stamped on tang.
|
05-05-2019, 07:10 AM | #4 |
Senior Member
Join Date: Oct 2016
Location: harpursville ny
Posts: 1,040
|
Re: Lincoln V-12 Distributor Parts
the condensers are most liklely no good. test them to be sure.
|
05-05-2019, 01:54 PM | #5 |
Senior Member
Join Date: May 2010
Location: Alabama
Posts: 3,260
|
Re: Lincoln V-12 Distributor Parts
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|