|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-07-2021, 01:17 AM | #1 |
Junior Member
Join Date: Apr 2018
Location: Eye duh hoe
Posts: 4
|
31 Coupe window side channels
I've been fussing with this for literally decades, but only found out about the channels with the riveted hooks a few years back. Finally got a set from Brattons. They have hooks on both ends, which matches the metal channels on the car. I read in a post from 5 years ago, that the originals were stretched into place. These don't stretch. If they did, they would be a perfect fit. So what does everyone do? Do you bend the tabs, and then try to bend them back ? It seems that they would stretch a little and fit if one could get enough leverage, but I haven't figured out the right angle yet.
|
09-07-2021, 01:55 AM | #2 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,214
|
Re: 31 Coupe window side channels
Bend top tab to install, then snug to fit. Doing a 34 ccpu with similiar channels I think.
Also read where pop rivets have been used. |
Sponsored Links (Register now to hide all advertisements) |
|
09-09-2021, 04:09 PM | #3 |
Junior Member
Join Date: Apr 2018
Location: Eye duh hoe
Posts: 4
|
Re: 31 Coupe window side channels
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|