|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-08-2020, 11:33 PM | #1 |
Senior Member
Join Date: Oct 2016
Location: western NC
Posts: 139
|
hoping I have a single disc clutch
I will be removing the starter from our early '28 Coupe tomorrow to get it rebuilt. The engine block has been replaced at some point with a '30 model block. I hope the early multi-plate clutch was swapped for a single disc when the engine block was changed. I will be looking, trying to figure out which I have while I'm under the car. I have the floor boards out now.
The clutch works well but I'm thinking about when/if the time comes for replacement $$$$$. |
01-08-2020, 11:56 PM | #2 |
Senior Member
Join Date: Aug 2012
Posts: 888
|
Re: hoping I have a single disc clutch
If you have the floor boards out you should be able to tell pretty easily if you pull the inspection cover off the bell housing.
__________________
The Master Cylinder Enjoying life at the beach in SoCal... |
Sponsored Links (Register now to hide all advertisements) |
|
01-09-2020, 10:29 AM | #3 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,462
|
Re: hoping I have a single disc clutch
Finding multi-plate clutches is pretty rare. Most didn't last very long and the Ford dealers followed the service bulletin for replacement.
|
01-09-2020, 10:57 AM | #4 |
Senior Member
Join Date: Oct 2016
Location: western NC
Posts: 139
|
Re: hoping I have a single disc clutch
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|