The Ford Barn

Lefthander1930 · 04-04-2021, 01:20 AM

IS there a way to find out where my Victoria made ?

Oldbluoval · 04-04-2021, 05:55 AM

Look at mafca website index
“Assembly plant”

shew01 · 04-04-2021, 07:47 AM

https://www.mafca.com/data_aplant_id_numbers.html

Sent from my iPhone using Tapatalk

Steve Plucker · 04-04-2021, 08:54 AM

The Murray Corporation built the body...From there those bodies were shipped to the varrious Ford Assembly plants throughout the world. Some in Knock-Down form...some already painted and ready for assembly.

Not sure if there is an Assembly Plant code on these bodies or not.

The only sure way to figure out where your car was assembled...as long as it is the ORIGINAL body that was mated to the ORIGINAL chassis with ORIGINAL engine, is to find the ORIGINAL Assembly Plant Bill of Sale or Dealer Bill of Sale which may get you close.

Pluck

Bob Bidonde · 04-04-2021, 10:17 AM

I looked all over my Steel-back for an assembly plant code, but I did not find one.

Oldbluoval · 04-04-2021, 02:04 PM

Sponsored Links (Register now to hide all advertisements)

Yeah I’ve found very few thru the years
Wooden sills seem to be the hardest to find

04-04-2021, 01:20 AM	#1
Lefthander1930 Senior Member Join Date: Nov 2015 Location: Roseville Ca. Posts: 141	Where was it made ? IS there a way to find out where my Victoria made ?

04-04-2021, 05:55 AM	#2
Oldbluoval Senior Member Join Date: Jun 2015 Location: Signal Mtn, TN (SE TN) Posts: 2,370	Re: Where was it made ? Look at mafca website index “Assembly plant”

04-04-2021, 07:47 AM	#3
shew01 Senior Member Join Date: Sep 2016 Location: Roanoke, VA USA Posts: 1,908	Re: Where was it made ? https://www.mafca.com/data_aplant_id_numbers.html Sent from my iPhone using Tapatalk

04-04-2021, 08:54 AM	#4
Steve Plucker BANNED Join Date: May 2010 Location: Walla Walla, Washington USA Posts: 6,066	Re: Where was it made ? The Murray Corporation built the body...From there those bodies were shipped to the varrious Ford Assembly plants throughout the world. Some in Knock-Down form...some already painted and ready for assembly. Not sure if there is an Assembly Plant code on these bodies or not. The only sure way to figure out where your car was assembled...as long as it is the ORIGINAL body that was mated to the ORIGINAL chassis with ORIGINAL engine, is to find the ORIGINAL Assembly Plant Bill of Sale or Dealer Bill of Sale which may get you close. Pluck

04-04-2021, 10:17 AM	#5
Bob Bidonde Senior Member Join Date: May 2010 Location: Long Island, NY Posts: 3,462	Re: Where was it made ? I looked all over my Steel-back for an assembly plant code, but I did not find one. __________________ Bob Bidonde

04-04-2021, 02:04 PM	#6
Oldbluoval Senior Member Join Date: Jun 2015 Location: Signal Mtn, TN (SE TN) Posts: 2,370	Re: Where was it made ? Sponsored Links (Register now to hide all advertisements) Yeah I’ve found very few thru the years Wooden sills seem to be the hardest to find

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode