|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-03-2021, 01:53 PM | #1 |
Senior Member
Join Date: Dec 2013
Location: The Netherlands
Posts: 387
|
Owen dyneto 1B question
I would love some help with my Owen Dyneto windshield wiper. Basically I need the set up of the main (drive) shaft. A picture with the cover taken off, showing the installed shaft would really help !
I guess mine has been fiddled around with. On the outside there (from left to right) is the hand operating lever, then the wiper arm, then a spring, then the housing. On the inside there is the little gear, a spring, a washer, a pin. This set-up is responsible for the wiper arm being mounted too far away from the backing plate, hence I need to add extra rubber to instal the wiper and on the inside of the car the shafts are too short to install any levers. All help is welcomed, Henk |
03-03-2021, 05:54 PM | #2 |
Senior Member
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 1,279
|
Re: Owen dyneto 1B question
Does this help?
|
Sponsored Links (Register now to hide all advertisements) |
|
03-04-2021, 08:17 AM | #3 |
Senior Member
Join Date: Dec 2013
Location: The Netherlands
Posts: 387
|
Re: Owen dyneto 1B question
Sponsored Links (Register now to hide all advertisements)
Henk |
|
|
Sponsored Links (Register now to hide all advertisements) |
|