F 150 OD trans

[T&A Flathead]

Originally Posted by MAG

"At the moment I’m dealing with moser engineering on splining the shaft of the transmission. "They have no recollection of doing these for others in the past."

I don't understand this. I just got two of them back last week from Moser. And I have had a couple others done in past few years. They cut them to length, splined and drilled/tapped the end for the u-joint. I send them a Model A rear transmission shaft and a u-joint to use as reference/guide. Never had any problem getting them to do it or with their work. They can no longer spline the drive shaft because it is too long for their equipment.

I am needing 2 shafts done. Have you made a drawing or instructions for moser so they get it right. I want to send them mine as well. Thanks.