|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-12-2015, 01:23 AM | #1 |
Member
Join Date: Oct 2014
Location: Minneapolis Minnesota
Posts: 55
|
FOUND! `35 cast iron intake with tall generator mount
City:
Minneapolis
State:
Minnesota
Sponsored Links (Register now to hide all advertisements)
I need an intake manifold with the taller 4" generator flange. Here are the dimensions: Each measurement is taken from the base of the manifold, where it mounts to the engine. The pump/vent height is 2 5/16" The carb mount is 5 1/8" The generator mount is 4" to the top, and about 3 1/2" to the center of the bolt. I want to stay correct with cast iron. I will need a vacuum port, mine is below the 3rd bolt from the front, on the drivers side. Last edited by wingerdinger; 01-13-2015 at 05:09 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|