|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-20-2010, 03:41 PM | #1 |
Member
Join Date: May 2010
Location: St. Louis, MO
Posts: 89
|
VIN Location on a '35-'37 "Big" Truck
Is the VIN in the same basic location, on the top of left frame rail, as on passenger cars and pickups? Is it located anywhere else?
I need to find it and get it right to apply for a duplicate title. Thanks. Clay |
05-20-2010, 05:34 PM | #2 |
Senior Member
Join Date: May 2010
Location: Rochester, Il
Posts: 599
|
Re: VIN Location on a '35-'37 "Big" Truck
As I understand it was stamped into the top of the bell housing. You'd have to remove the transmission cover to see it. Stu
|
Sponsored Links (Register now to hide all advertisements) |
|
05-20-2010, 06:01 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mid coast Maine
Posts: 1,878
|
Re: VIN Location on a '35-'37 "Big" Truck
I would near the steering box top frame rail.
|
05-21-2010, 05:39 AM | #4 |
Senior Member
Join Date: May 2010
Location: Sinclairville NY
Posts: 230
|
Re: VIN Location on a '35-'37 "Big" Truck
Legability is best on the trans flange and the best to get a tracing from as what NY wants. I have one with no numbers but most do, understand factory replacements were the only ones blank. Some big trucks have a data plate and include the VIN riveted inside the glove box door, but the ones I had were postwar, maybe not done early.
|
05-21-2010, 08:14 AM | #5 |
Member
Join Date: May 2010
Location: DeWitt, IL
Posts: 53
|
Re: VIN Location on a '35-'37 "Big" Truck
I just found my '36 BB number on the top of the frame near the steering box. It took a lot of scrubbing with a wire brush to find it. After you find it, rub with a white crayon to make it more legible. It will start out " BB18-xxxxxxx " with a star at each end.
|
05-21-2010, 09:34 AM | #6 |
Member
Join Date: May 2010
Location: St. Louis, MO
Posts: 89
|
Re: VIN Location on a '35-'37 "Big" Truck
Sponsored Links (Register now to hide all advertisements)
Here is some info from the HAMB on how to "raise" the chassis numbers if they are to faint to read. http://www.jalopyjournal.com/forum/s...highlight=acid |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|