|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-30-2017, 08:39 PM | #1 |
Senior Member
Join Date: May 2010
Location: Dallas TX
Posts: 112
|
Widebed fender detail pictures needed
I need a picture of a wide bed rear fender at the fender bracket location where it attaches to the bed. Both of my rear fenders are damaged in this location and have poor repairs. I can't tell if there is an offset in the fender mounting flange at this location or not. Also if the mounting hole in the flange is round or elongated. Of all the widebed fender photos posted here, none show this area.
|
07-31-2017, 12:44 AM | #2 |
Senior Member
Join Date: Dec 2010
Location: Verdi, Nevada
Posts: 166
|
Re: Widebed fender detail pictures needed
4port: Send me your email address. I'll send you a photo of my fender. Hole in the flange is square,, at least mine is.
Rick Jensen [email protected] |
Sponsored Links (Register now to hide all advertisements) |
|
07-31-2017, 06:43 AM | #3 |
Senior Member
Join Date: May 2010
Posts: 1,987
|
Re: Widebed fender detail pictures needed
I have 2 nos in my shop, there is no offset there, I believe all the hole were oblong, none square, I'll check later and post pic....
|
07-31-2017, 08:47 AM | #4 |
Senior Member
Join Date: May 2010
Location: Dallas TX
Posts: 112
|
Re: Widebed fender detail pictures needed
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|