Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 05-13-2010, 09:05 AM   #1
a31vicky
Junior Member
 
Join Date: May 2010
Posts: 1
Default Exhaust/Intake gasket

I have used a black fiber 1 piece gasket in past with excellent results. Don't remember where I purchased. Does anyone know of a supplier? If not, what is best product currently on market. Thanks. a31vicky
a31vicky is offline   Reply With Quote
Old 05-13-2010, 09:45 AM   #2
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Default Re: Exhaust/Intake gasket

I've only used the copper with filler in the center and had excellent results. I also use the gland rings, except due to slight warpage I can't get the rear one in my 28.
Tom Wesenberg is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 05-13-2010, 09:53 AM   #3
Mitch//pa
BANNED
 
Join Date: May 2010
Location: Bucks County, PA
Posts: 11,454
Default Re: Exhaust/Intake gasket

Sponsored Links (Register now to hide all advertisements)
i use the copper also and usually replace the studs and manifold dish washers and brass nuts. it gives it a clean fresh look
Mitch//pa is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:56 AM.