|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-31-2020, 06:17 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 2,871
|
Electrical Fire Hazard.
For those of you who are fortunate to own machine shop equipment, this was a lesson learned. The other day I was outside the house on the rear deck and smelled smoke. It smelled like electrical, I traced it to the the basement where there was a drift of smoke up near the ceiling. I could hear a humming noise coming from the 220 drive motor for the lathe which was the source of the smoke. I flipped off the CB, and the noise stopped. Put my hand on the motor, and it was plenty hot. After disconnecting the wiring to the motor, I opened up the forward reverse switch to see If could spot a problem. The only thing I saw that was unusual was one of the 3 contacts in the switch was showed severe arcing. I went to electric motor shop that rebuilt the motor a year or so ago to see what they thought. What I was told is that as the the spring contacts in the drum type switch loose tension over years of use. What had happened was the 1 side of the 220 line, 120 volts was being fed to motor start winding, but was not enough current to run the motor so it was stalled. I have a disconnect switch for the forward reverse switch for the 220 line to the Bridgeport, but not one for the lathe. I will install a disconnect switch for the lathe and compressor. Dodged a bullet on that one.
Last edited by russcc; 02-22-2021 at 01:17 PM. |
08-31-2020, 06:20 PM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,944
|
Re: Electrical Fire Hazard.
WOW. Glad you were home and caught it.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-01-2020, 12:52 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 886
|
Re: Electrical Fire Hazard.
You certainly got lucky ,glad it didn't short out while you and your family were sleeping, I turn the power off to all machine circuits while they are not in use, (an old habit ) I have the lights wired to work separately , my compressor motor starter is series wired to a wall switch next to the lights so I can conveniently turn it on and off as I enter and leave the shop .
|
09-01-2020, 01:07 PM | #4 |
Senior Member
Join Date: Oct 2015
Location: Bonita, CA
Posts: 1,374
|
Re: Electrical Fire Hazard.
You might want to replace that breaker with a lower amperage rating because it should "pop" with a load light that.
|
09-01-2020, 03:49 PM | #5 |
Senior Member
Join Date: Mar 2011
Location: upstate NY
Posts: 478
|
Re: Electrical Fire Hazard.
From the picture, it looks like you have the red and white wire under one terminal. Is there a reason to hook it up this way?
If the motor is of any size 1/2 hp and above. I would suggest, a starter with a set of properly sized overloads to protect the motor. But that's just the sparky in me. |
09-02-2020, 03:24 PM | #6 |
Senior Member
Join Date: Jun 2010
Location: Perry OH
Posts: 1,330
|
Re: Electrical Fire Hazard.
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|