banjo toqure tube

[rotorwrench]

Find a long piece of schedule 40 PVC and some caps to ship it.

[JM 35 Sedan]

I hate not being able to edit a post after its been up for ~ 24 hours!! Post #18 should have read...."I believe I have a good one in my stash, but shipping would probably be expensive".

Originally Posted by jiw1

JM 35, hav'ent found one yet so i am interested.can you PM me on price.thank you,john

John, I will check the condition of the one I have tomorrow and let you know...probably by sending you a PM.

[tracktguy]

I have a one with very minor pitting. If interested I would take a couple of pictures. I'm in Minnesota so I could ship speeDee. They are cheaper than UPS. It came from a '48 and it has the coupler on it also. Gene

[tracktguy]

Here is a couple of pictures of the one I have to sell if you are interested. Couple that connects to pinion is also on it.

[jiw1]

trackguy i am interest,it does look much cleaner then mine,do you have a picture of the shaft at the center bearing area that you can send? thanks

[tracktguy]

Sponsored Links (Register now to hide all advertisements)

There is a little ridge on the shaft. You hope fully can see some uneven wear on that part of the shaft. Just thought I would let you know about this.

[JM 35 Sedan]

Here are some pics of the one I have alongside a '38-'41 ds that's ~ 2" shorter than a '42-'48 ds. This '42-'48 driveshaft has good splines on the U joint end, no wear in the center bearing area, and some wear on the pinion end splines.