|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-27-2019, 09:06 AM | #1 |
Senior Member
Join Date: Oct 2016
Posts: 250
|
36 gas gauge calibration
Ok, I’m attempting to use a ‘52 ford sending unit for the gauge on my ‘36. At first I wasn’t getting any continuity between the terminal and the case, which I think is correct. I hooked it up to a gauge and a 6V battery and at “Full” on the sending unit the gauge was only reading 1/2. So I came back to the bench to try and see if there was any adjustment. Now I’m getting continuity between the terminal and the case??
Questions: Is there any adjustment? Should I have continuity between the terminal and the housing? Please help! |
10-27-2019, 12:59 PM | #2 |
Senior Member
Join Date: Oct 2016
Posts: 250
|
Re: 36 gas gauge calibration
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|