|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-03-2020, 11:17 AM | #1 |
Senior Member
Join Date: Apr 2017
Posts: 122
|
32 panel delivery serial number location
Can you see the serial number stamped on the top of the frame without removing anything on a 32 panel. Did the commercial vehicles get stamped different?
|
03-03-2020, 11:20 AM | #2 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,301
|
Re: 32 panel delivery serial number location
As far as I know they were stamped in the same areas.Without removing the body you "should " see numbers stamped on top the frame at the steering box location.
|
Sponsored Links (Register now to hide all advertisements) |
|
03-03-2020, 11:27 AM | #3 |
Senior Member
Join Date: Apr 2017
Posts: 122
|
Re: 32 panel delivery serial number location
Does the fender cover the top of the frame.
|
03-03-2020, 11:35 AM | #4 |
Junior Member
Join Date: Aug 2018
Location: Granada Hills CA
Posts: 9
|
Re: 32 panel delivery serial number location
That's where I found mine on my 39 1 ton (photo attached)
Had to clean off several layers of paint to find it. |
03-03-2020, 12:24 PM | #5 |
Senior Member
Join Date: May 2010
Location: Southern France
Posts: 5,301
|
Re: 32 panel delivery serial number location
I failed to mention that on the '32 the fender lip sits on top the frame.In the space between the foot of the firewall and lip of the fender you might see the numbers.If your car had the original trans the number is also stamped on the bellhousing ,center top below the lip of the flange.David G hopefully might chime in and post a pic of those locations. |
03-03-2020, 12:50 PM | #6 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,093
|
Re: 32 panel delivery serial number location
Sponsored Links (Register now to hide all advertisements)
While there are some minor variations given that the numbers were hand stamped your number should be at or just in front of the foot of the firewall on the left side close to the inner edge of the frame rail. The original webbing under the left front fender was notched to permit seeing the number without removing the fender and its webbing. But, despite the specific instructions from Dearborn of where to stamp the engine number, exceptions are not unheard of. |
03-03-2020, 12:51 PM | #7 |
Senior Member
Join Date: Apr 2017
Posts: 122
|
Re: 32 panel delivery serial number location
I'm going to look at one this weekend. I just want to make sure the title matches the frame. The trans could have been changed at some point.
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|