Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-03-2020, 01:47 AM   #1
Lawrie
Senior Member
 
Lawrie's Avatar
 
Join Date: May 2010
Location: Qld, Australia
Posts: 3,579
Default C69A block

I have made a blue on my spare engine, Didn't,t check the wall thickness before I bored it (3-3125),Turns out one cylinder has a part of the wall at .070 thick, this made a squeak at idle that I think was the bore letting the comp past,
So, I sort through my spare blocks and find one that looks good, Its a C69A and has the oblong water passages above the valves like an 8ba, instead of the usual small round ones, is this a Canadian only thing?
Also what do you use to mount the engine stay rods to if you use an 8ba block in an early car.
Thanks Lawrie
Lawrie is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:20 PM.