|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-24-2010, 09:31 AM | #1 |
Member
Join Date: May 2010
Location: Devils Lake ND
Posts: 45
|
clutch release bearing
Turn the bearing until the lubricator fitting is at the top? I see no fitting on the bearing, I see a stationery fitting near the spring but nothing to turn. Could someone explain this.
|
07-24-2010, 09:48 AM | #2 |
Senior Member
Join Date: May 2010
Location: on the Littlefield
Posts: 6,173
|
Re: clutch release bearing
I believe that is for the milti disc clutch in 1928
|
Sponsored Links (Register now to hide all advertisements) |
|
07-24-2010, 10:05 AM | #3 |
Senior Member
Join Date: May 2010
Location: Tacoma, WA
Posts: 1,027
|
Re: clutch release bearing
mmmmm I don't believe the throwout bearing has a grease fitting. The sleeve has a fitting (by the spring)
|
07-24-2010, 10:10 AM | #4 |
Senior Member
Join Date: May 2010
Location: Littleton, Colorado
Posts: 241
|
Re: clutch release bearing
I am putting in a new clutch today in my '29 Coupe and I have everything all apart right now. The hub is the only thing that has a grease fitting. The throwout bearing is a sealed unit without a grease fitting.
As mentioned above, maybe the multi-disk units had a grease fitting but I do not know if they did or not. Hope that helps. Greg
__________________
"Betsy doesn't leak oil - she just marks her spot" |
07-24-2010, 10:16 AM | #5 |
Senior Member
Join Date: May 2010
Location: Didsbury Alberta
Posts: 838
|
Re: clutch release bearing
The hub has two holes that allows the grease to move into the center of the bearing between the two halves. You grease the hub, grease moves around and along the input bearing retainer, and escapes through the holes to the bearing.
|
07-24-2010, 10:42 AM | #6 |
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: clutch release bearing
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|