The Ford Barn

Pandersen33 · 04-28-2020, 03:24 PM

Has anyone done this? I am working on a 35 sedan and would like it to sit just a bit lower. However the Mitchell OD doesnt look like it has too much more room over it. Just curious if I need to look at more cutting or if another approach is necessary. Thanks

37 Cab · 04-28-2020, 03:32 PM

Sponsored Links (Register now to hide all advertisements)

I have a Mitchell in my 37 with reversed springs. I made a box 1 inch higher than the tunnel for clearance. 1+ wider on both sides for side to side movement.

04-28-2020, 03:24 PM	#1
Pandersen33 Member Join Date: Jun 2017 Location: Loomis, CA Posts: 47	Reverse eyed spring with Mitchell OD? Has anyone done this? I am working on a 35 sedan and would like it to sit just a bit lower. However the Mitchell OD doesnt look like it has too much more room over it. Just curious if I need to look at more cutting or if another approach is necessary. Thanks

04-28-2020, 03:32 PM	#2
37 Cab Senior Member Join Date: Dec 2014 Location: Miami Oklahoma Posts: 543	Re: Reverse eyed spring with Mitchell OD? Sponsored Links (Register now to hide all advertisements) I have a Mitchell in my 37 with reversed springs. I made a box 1 inch higher than the tunnel for clearance. 1+ wider on both sides for side to side movement. __________________ Tommy

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode