Fenders for 31 wide bed pickup?

[Curt Campbell]

I have looked thru catalogs and cannot find front and rear fenders for 31 wide bed closed cab pickup. Also checked Rootlieb. Are 31 car front fenders the same?

Who sells these fenders? Thank you in advance.

[2manycars]

Front fenders are the same.

[Bob C]

The only rear fenders available are fiberglass. Fronts are the same as cars but
the new ones take some work to get them to fit right.

Bob

[CarlG]

Originally Posted by foxfire42

Rears are a very tough find. As far as I know they are not being reproduced in steel. Fiberglass may be the only option until you can find some originals. I believe Snyders sell the fiberglass rears. At least you can get the fronts in steel.

If you absolutely want steel for now the only option is getting standard PU rears and have a master metal person make them wider.

Wide Bed rear fenders are narrower, not wider than standard PU rears.

[foxfire42]

CarlG, It was a test to see if anyone was paying
attention. You passed the rear fender class 101.

[DougVieyra]

Sponsored Links (Register now to hide all advertisements)

I know that the Front Fender steel reproductions, as bought, do not fit properly - by a long shot, and has to have the steel extensively reworked.

But what about the Fibreglass reproductions? Do they fit more correctly and are they easier to install than the steel fenders?

[Herb Concord Ca]

When I did my 31 Roadster P/U, I used fiberglass fronts and they fit like a glove, just had to drill the mounting holes. I bought Steel rear fenders and didn't have any trouble bolting them on either

[Larry Jenkins]

Look at Wescott's site. The best fiberglass fenders made.

[Charlie Stephens]

I thought this ad might be interesting.

http://www.fordbarn.com/forum/showthread.php?t=175980

I know nothing about it.

Charlie Stephens

[fordrelic]

I plan to make a set from standard truck fenders by cutting a section from center of fender and welding back together.

[Barry B./ Ma.]

I used coupe/ roadster rear fenders on the huckster I did. I mounted the fenders and cut them in half, down the middle, cut the middle out (after measuring the distance they stuck out from the running board) and welded them back together.