The Ford Barn

Bob C · 10-01-2016, 02:55 PM

Saw this on Little Dearborn's auction.
https://grafeauction.proxibid.com/as...p?lid=32326041

Bob

Ol' Ron · 10-01-2016, 05:20 PM

Now, that thinking out side the box. Kiddios to the guy that thought of that.

rotorwrench · 10-02-2016, 10:28 AM

I'd take the bale off & put a crab cap on there. The crab cap would sure look different in that location. That would certainly make a better distributor out of a boat anchor for multi carb set ups. It would be interesting to see how the drive was set up. A person would still have to adjust the timing but at least you can get to it to do that. Once it is set, a person could still pull the distributor to do maintenance without changing the timing.

skidmarks · 10-02-2016, 10:31 AM

Sponsored Links (Register now to hide all advertisements)

Pretty simple to make with a lathe. The drive adapter could be made from a old cam shaft

10-01-2016, 05:20 PM	#2
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,985	Re: Oal school Loadamatic modification? Now, that thinking out side the box. Kiddios to the guy that thought of that.

10-02-2016, 10:28 AM	#3
rotorwrench Senior Member Join Date: Jun 2010 Location: San Antonio, Texas Posts: 18,007	Re: Oal school Loadamatic modification? I'd take the bale off & put a crab cap on there. The crab cap would sure look different in that location. That would certainly make a better distributor out of a boat anchor for multi carb set ups. It would be interesting to see how the drive was set up. A person would still have to adjust the timing but at least you can get to it to do that. Once it is set, a person could still pull the distributor to do maintenance without changing the timing. Last edited by rotorwrench; 10-02-2016 at 10:33 AM.

10-02-2016, 10:31 AM	#4
skidmarks Senior Member Join Date: Aug 2010 Location: newark, delaware Posts: 3,841	Re: Oal school Loadamatic modification? Sponsored Links (Register now to hide all advertisements) Pretty simple to make with a lathe. The drive adapter could be made from a old cam shaft

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode