Yes, they are still out there NUMBER 2

[Bruce in southern OH]

Yes Vic, I installed using the original parts I got with car, heater works well. I did not want to take a chance on disturbing the head/ head gasket so I relocated blower to fender well, if I had more time I could have hard piped, making a tube that would look like a factory pipe. (will do later) There would be a lot of heat on the little motor in summer time, I now will probably leave installed, it will be something everyone will want to ask "what is that"?? I will tell them it is an "exhaust induction multiplier". This afternoon I freed up both of the defrost cables and got them operational. Also installed the drivers side glove box back in car, installed three modern gauges, mechanical oil, mechanical water temp and voltage meter, hid them in back of glove box. Will go down to Don P. this week to see if he has a 12 Volt small blower motor that I can use on heater system. Last but not least, need to have head light switch installed, there is not any place in the dash to install. Old head light switch is good but a bear to work on underneath the radio controls.
.
New gauges in the car to monitor the engine, now you see them.
.

.
Now you do not see them!!!
.