Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page Starter/flywheel problem

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 11-20-2014, 11:00 PM   #6
skidmarks
Senior Member
 
skidmarks's Avatar
 
Join Date: Aug 2010
Location: newark, delaware
Posts: 3,841
Default Re: Starter/flywheel problem
Sponsored Links (Register now to hide all advertisements)
Easy way to tell them apart is the width of the ring gear looking at the backside. 8ba is narrower then the 59AB. The 59ab will be too close to the back of the block on a 8ba. We made some aluminum shims up to run 59ab aluminum flywheels on 8ba motors. Why? Because we had a bunch of.early.flywheels and late motors
skidmarks is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:47 AM.