|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
08-17-2014, 06:32 AM
|
#5 |
|
Senior Member
Join Date: May 2010
Location: Cincinnati, OH
Posts: 1,465
|
Re: sloppy clutch actuation shaft
What is your chassis application? Ford made several designs of the ball pivot mounting bracket....all had the same ball. They do wear over time. A fresh split bushing only helps a bit if the ball is worn. Also the inside end of the actuation shaft could be worn. New parts would help. Also the bracket must be tight to the frame.
__________________
VANPELT SALES LLC Cincinnati, Ohio Office: 513-724-9486 www.vanpeltsales.com www.classictransmission.com |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:09 PM.