The Ford Barn

A V8 Al · 09-13-2013, 04:39 PM

The two choke heat tubes on my 260 V8 Falcon Sptrint have rotted and broken off at the point they enter the exhaust manifold. What is the best way to remove the remaining tube from the manifold. Also, how are the new tubes secured to the manifold holes?...is it fust a pressure fit? Thanks, Al

Blue Futura · 09-13-2013, 05:48 PM

Sponsored Links (Register now to hide all advertisements)

I drilled mine out on a 289 , very careful so i would no oversize it. Then just installed another new one . It fit's a little loose but stays in and works good .

09-13-2013, 04:39 PM	#1
A V8 Al Junior Member Join Date: May 2010 Posts: 16	260 V8 choke heat tubes The two choke heat tubes on my 260 V8 Falcon Sptrint have rotted and broken off at the point they enter the exhaust manifold. What is the best way to remove the remaining tube from the manifold. Also, how are the new tubes secured to the manifold holes?...is it fust a pressure fit? Thanks, Al

09-13-2013, 05:48 PM	#2
Blue Futura Member Join Date: Jul 2013 Location: South west Idaho Posts: 45	Re: 260 V8 choke heat tubes Sponsored Links (Register now to hide all advertisements) I drilled mine out on a 289 , very careful so i would no oversize it. Then just installed another new one . It fit's a little loose but stays in and works good . __________________ 64 Futura , bought new. 56 ford fairlane , bought about 30 years ago. 35 chevy street rod , started building in 2000.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode