Introduction - The Ford Barn

		The Ford Barn > General Discussion > Early V8 (1932-53)
Introduction

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

05-08-2013, 07:53 AM	#8
36tbird Senior Member Join Date: May 2010 Location: nw SanAntonio, TX Posts: 940	Re: Introduction I have a hard time imagining a Cad shoe horned into a '37 pickup engine compartment. Is it done "old school" with an adapter to the Ford trans.? If you need a flathead, I have one that I soon hope to start on an engine stand up here by San Antone. Welcome to the 'barn.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 08:59 PM.