|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
03-07-2013, 11:39 PM
|
#4 |
|
Senior Member
Join Date: Feb 2012
Location: Louisiana
Posts: 117
|
Re: Carb bowl gasket
Steve, I didn't know there were different versions used on the Model T. Synder's shows a couple of different gaskets so I was hoping one would be the size I need, which is ID = 2.625, OD = 2.725, thickness = .025
I'll just ask them to measure the ones they sell. I did cut my own gasket and it will work, but it could be better - ya know. |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:05 PM.