The Ford Barn

Mark Slight · 03-03-2013, 11:14 AM

Thanks Brad in Germany,

It is interesting to see on the model "A" tool check, it is spelled out "Tool Check". There is no question as to what it was intended for. Thank you very much for your input.

Mark

FL&WVMIKE · 03-03-2013, 01:54 PM

Did you notice in my post #8, that one ring of chits, belonged to FORD employee #54 ? He must have been one of FORD'S first employees and worked on the first FORD automobiles.
MIKE

ford38v8 · 03-03-2013, 10:14 PM

Quote:

Originally Posted by FL&WVMIKE

Did you notice in my post #8, that one ring of chits, belonged to FORD employee #54 ? He must have been one of FORD'S first employees and worked on the first FORD automobiles.
MIKE

Mike, each plant had their unique set of employee numbers, many plants being so large that each department within the plant would be denoted by a prefix letter followed by the employee number.

FL&WVMIKE · 03-04-2013, 01:59 PM

Mark Slight ......................
I'm sure that you are correct on that.
MIKE

Nodakwalleyer · 03-06-2013, 01:43 PM

When I was in the Air Force we had a ring with 10 Chits on it, we would check out special tools or vehicles during the day from our tool crib, each person assigned a number, after about 10 years we got rid of the chits and everything was bar coded and scanned.

03-03-2013, 11:14 AM	#1
Mark Slight Senior Member Join Date: May 2010 Location: Dixon, CA Posts: 473	Re: \"Tool Chits\" Thanks Brad in Germany, It is interesting to see on the model "A" tool check, it is spelled out "Tool Check". There is no question as to what it was intended for. Thank you very much for your input. Mark

03-03-2013, 01:54 PM	#2
FL&WVMIKE Senior Member Join Date: May 2010 Location: Daytona Beach, Fl & Spencer, W. Va, Posts: 4,449	Re: \"Tool Chits\" Did you notice in my post #8, that one ring of chits, belonged to FORD employee #54 ? He must have been one of FORD'S first employees and worked on the first FORD automobiles. MIKE

03-04-2013, 01:59 PM	#4
FL&WVMIKE Senior Member Join Date: May 2010 Location: Daytona Beach, Fl & Spencer, W. Va, Posts: 4,449	Re: \"Tool Chits\" Mark Slight ...................... I'm sure that you are correct on that. MIKE

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-06-2013, 01:43 PM	#5
Nodakwalleyer Member Join Date: Oct 2012 Location: Grand Forks, North Dakota Posts: 54	Re: \"Tool Chits\" When I was in the Air Force we had a ring with 10 Chits on it, we would check out special tools or vehicles during the day from our tool crib, each person assigned a number, after about 10 years we got rid of the chits and everything was bar coded and scanned.