|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
12-08-2012, 08:26 PM
|
#1 |
|
Senior Member
Join Date: Jan 2011
Posts: 451
|
Re: 59A-B parts into an 8BA block
RE the 7/16 bolt replacing the fuel pump rod,
"I would just put a short 7/16 bolt down the fuel pump push rod hole because the 8BA rod bushing has a little pee hole half way down the hole that goes into the main oil line." Do u use JB Weld, Silicone, or anything to keep the bolt from bouncing out? |
|
|
|
12-08-2012, 09:09 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Gardiner Me.
Posts: 4,200
|
Re: 59A-B parts into an 8BA block
19Forty. I like that oil filler cap with the plug for the rod bushing. I would install a bung on the low side of that filler pipe for a PCV valve. Walt
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:31 PM.