Model A water pump pulley alignment - The Ford Barn

		The Ford Barn > General Discussion > Model A (1928-31)
Model A water pump pulley alignment

Sponsored Links (Register now to hide all advertisements)

Prev

Previous Post

Next Post

Next

04-30-2026, 10:22 AM	#17
Himi52 Junior Member Join Date: Apr 2019 Location: Newport Beach, Ca Posts: 26	Re: Model A water pump pulley alignment I was able to remove the fan by using a small wheel puller with three arms. I took the key out and spun the fan and found some places that needed to be filed. I am going to try a dry fit to see if the pulleys are lined up. I am hoping that the taper in the fan is a correct match for the shaft. I will keep you posted. Thanks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 01:41 AM.