|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
04-14-2026, 07:30 AM
|
#7 |
|
Senior Member
Join Date: May 2010
Location: imperial,mo
Posts: 781
|
Re: Adapting hydraulic brakes to 34 spindle
Tim Brown is correct that the grease seal runs on the spacer, but the PRIMARY reason for the spacer is to move the hub outboard on the spindle so that the edge of the brake drum does not make contact with the backing plates. Like I said before, I'm doing this from memory so please let us know how it works out.
Tom |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:42 PM.