|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
04-13-2026, 10:57 PM
|
#1 |
|
Senior Member
Join Date: Jan 2011
Location: Beverly Kansas
Posts: 5,558
|
Re: Adapting hydraulic brakes to 34 spindle
I agree with Tim, its the seal surface, the 34 had no seal. I did one with the kit from Lecy, v8 garage, and my spacers were a bit loose too. I peened the spindle a bit, then red locktite. I also welded up the holes in the backing plate and re drilled to 34 spindle size.
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 06:04 PM.