|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
|
|
03-24-2026, 01:23 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Mill Valley,Ca.
Posts: 1,555
|
Re: Axle coupler pin staking
There's also an aftermarket safety deal, a strap goes halfway around the shaft. Holes are in both ends for the pin to go thru the pin is peened on the out side, Thusly, if the pin is sheered, the strap holes the parts of the pin from getting out.
Karl |
|
|
|
03-25-2026, 05:37 AM
|
#2 | |
|
Senior Member
Join Date: Sep 2014
Location: Mid-Coast Maine
Posts: 3,349
|
Re: Axle coupler pin staking
Quote:
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
04-02-2026, 10:33 PM
|
#3 |
|
Senior Member
Join Date: Aug 2012
Location: Perth, Western Australia
Posts: 2,708
|
Re: Axle coupler pin staking
Be careful on peeing over not to keep going too long smacking at it as it will just weaken the head. Also a pic showing the heat shrink sleeve I use.
__________________
"Came too close to dying to stop living now!" |
|
|
|
|
04-02-2026, 10:48 PM
|
#4 | |
|
Senior Member
Join Date: May 2015
Posts: 11,658
|
Re: Axle coupler pin staking
Quote:
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Hybrid Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:47 AM.