Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page '41 pickup accelerator rod

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-02-2026, 10:23 AM   #19
glennpm
Senior Member
 
glennpm's Avatar
 
Join Date: Sep 2014
Location: Mid-Coast Maine
Posts: 3,346
Default Re: '41 pickup accelerator rod
Quote:
Originally Posted by joel View Post
Update on my accelerator issue; I made one using three sixteenths dia. stainless rod and ends from Speedway. After installation and checking travel. and careful measuring , I get ten inches between the two pivots. Also the "spoon" is farther off the floor.
Good!



__________________
Archives of historical but relevant older articles:
 -------------
Hover mouse over the links below and click!
~~~~~~~~~~~~~~~~~---------------
Rumble Seat’s Notes
Techno Source for the 1932 thru 1953 Flathead Ford
glennpm is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:32 PM.