Go Back   The Ford Barn > General Discussion > Model A (1928-31)
Reload this Page Removing broken head studs from block

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-01-2025, 10:52 AM   #10
Dan Partain
Senior Member
 
Dan Partain's Avatar
 
Join Date: May 2010
Location: Hangtown, CA
Posts: 571
Default Re: Removing broken head studs from block
Have you tried pre-heating the broken stud with a torch to get better penetration with the mig welder? I haven't tried it yet, but have been thinking about it since I've had similiar negative results in getting the nut to stay attached to the stud from the cold weld.
Dan Partain is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:52 PM.