The Ford Barn

Thomas Sargent · 03-28-2025, 02:59 PM

EFI project completed. Engine started instantly on the first try. This is the autotrend unit from CA. Installed Manifold pressure sensor, ambient air temp sensor, coolant sensor, idle air control motor, , throttle position sensor was on throttle body, and one wire went to coil. installed O2 sensor in pas ex pipe, and a Holley HP processor under the seat, pass side. Put in the tank fuel pump and pressure reg in engine compartment. Lots more details, DSC02703.jpg

DSC02705.jpg

DSC02707.jpg

IMG_8683.jpg

03-28-2025, 02:59 PM	#16
Thomas Sargent Member Join Date: Oct 2017 Location: Erie Pa Posts: 71	Re: 40 flathead EFI EFI project completed. Engine started instantly on the first try. This is the autotrend unit from CA. Installed Manifold pressure sensor, ambient air temp sensor, coolant sensor, idle air control motor, , throttle position sensor was on throttle body, and one wire went to coil. installed O2 sensor in pas ex pipe, and a Holley HP processor under the seat, pass side. Put in the tank fuel pump and pressure reg in engine compartment. Lots more details, DSC02703.jpg DSC02705.jpg DSC02707.jpg IMG_8683.jpg

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode