Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)
Reload this Page 3D Printed Ford Battery Case Help

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-15-2025, 10:35 AM   #11
Karl Wescott
Senior Member
 
Karl Wescott's Avatar
 
Join Date: May 2010
Location: Oregon
Posts: 1,663
Default Re: 3D Printed Ford Battery Case Help
A thought...


If you can get the battery cables to fit well enough to work properly but the post is too low, consider making a dummy 3D extension of the post which should be able to look good and get squished slightly on installation to keep it in place.
Karl Wescott is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:31 PM.