|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-06-2025, 03:15 PM
|
#11 |
|
Senior Member
Join Date: May 2010
Location: Minnesota
Posts: 2,156
|
Re: 3D Printed Ford Battery Case Help
I know it would be mixing technologies and not what you are intending to do; but due to that complicated pattern wouldn't it possible to pull a mold off an original case and cast the side and end panels out of resin and in the same light cast the cell connectors out of lead.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:49 AM.