The Ford Barn

Grayble 123 · 12-25-2024, 08:35 PM

I do have the slip yoke for the C4. I read one of the threads where a couple guys said he used the old drive line. I haven’t measured the length needed for the new shaft yet. But I have contacted a local shop for a price quote.

paul2748 · 12-25-2024, 08:39 PM

If your old shaft is longer tha what you needed, it can be cut down to fit. A shop can attach the correct end for the c4 yoke.

Grayble 123 · 12-25-2024, 09:26 PM

I plan on taking with me if it is longer.

12-25-2024, 08:35 PM	#1
Grayble 123 Junior Member Join Date: Oct 2023 Location: Maryville,Tn Posts: 26	Re: 1951 Flathead to C4 drive shaft advice I do have the slip yoke for the C4. I read one of the threads where a couple guys said he used the old drive line. I haven’t measured the length needed for the new shaft yet. But I have contacted a local shop for a price quote.

12-25-2024, 08:39 PM	#2
paul2748 Senior Member Join Date: May 2010 Location: Midland Park, NJ Posts: 4,406	Re: 1951 Flathead to C4 drive shaft advice If your old shaft is longer tha what you needed, it can be cut down to fit. A shop can attach the correct end for the c4 yoke. __________________ 48 Ford Conv 56 Tbird 54 Ford Victoria

12-25-2024, 09:26 PM	#3
Grayble 123 Junior Member Join Date: Oct 2023 Location: Maryville,Tn Posts: 26	Re: 1951 Flathead to C4 drive shaft advice I plan on taking with me if it is longer.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode